My initial inspiration was from a piece of art that my parents own (partially seen behind my wonderful parents):
So, my husband envisioned something with a wooden frame, some twine and our corks. We went to Lowe's and got the supplies we needed and got started.
We knew it would go above the pantry door so we made it so that it would fit with about three inches on each side of the wall around it.
My husband sawed down the wood to the length we wanted and made 45 degree edges on each side to form the frame. He fastened the wood together with corner braces.
We chose to do 13 rows of 12 corks each. After evenly making the holes equal space apart, he drilled 13 holes through the top and bottom pieces of the frame.
We bought decorative wood to cover the frame, which he then measured, trimmed and fit to the frame. He glued the decorative wood to the frame and secured it with clamps to allow it to properly dry in place.
While that was drying, he drilled holes in 156 corks so that we could have 13 rows of 12 corks each. I strung the corks onto the twine however had to tape the edge of the twine to get it to easily pass through the corks.
I didn't want every row to be the same, so I would place a few corks on and tie a knot to secure them in place before putting more corks on and leaving about a half inch gap in between the previous corks. I did a different 'layout' for each strand of corks.
When that was finally finished, we assembled the rows of corks on the frame, tying a knot outside of the frame on each side.
We trimmed close to the edge of each knot and our project was complete!
Here it is hanging above the pantry door! What do you think?
Unfortunately we still have HUNDREDS of corks left....what cork inspired project
will be should be next?
Linking up to: